[Mageia-dev] drakxtools & drakx-installer-stage2 (mga#9428)

Fri Mar 22 23:57:22 CET 2013

On 22 Mar 2013 22:21, "Glen Ogilvie" <nelg at linuxsolutions.co.nz> wrote:
+>
+> On 23 March 2013 05:12, AL13N <alien at rmail.be> wrote:
+>>
+>> Op vrijdag 22 maart 2013 07:38:56 schreef Frank Griffin:
+>> > On 03/22/2013 07:20 AM, Glen Ogilvie wrote:
+>> [...]
+>> > > 1. How does the src tar.xz file for drakx-installer-stage2 get
+>> > > created?   I assume it comes from a
+>> > > build of svn://svn.mageia.org/svn/soft/drakx/trunk
+>> > > <http://svn.mageia.org/svn/soft/drakx/trunk>, but can't find how it
+>> > > ends up as a tar.xz
+>> >
+>> > I'm maybe about two days ahead of you on this, but here's what I think
+>> > happens, FWIW.  You do your checkout, and then in the mdk-stage1
+>> > subdirectory, do a "make dist-svn".  This should produce the tar.xz in
+>> > the mdk-stage1 directory.
+>> [...]
+>>
+>> "make dist" actually...
+>>
+>> it will target make "dist-svn" or "make dist-git" depending on if you're
+using
+>> git-svn or not.
+>>
+>> be advised that dist-svn uses the BASE and any uncommitted change will
+not be
+>> applied.
+>>
+>> dist-git however, you can commit without pushing them and that will be
+used.
+>>
+>
+> I've had a good play around with make dist.
+> It seems to me, like running make dist in the perl-install directory,
+(svn://svn.mageia.org/svn/soft/drakx/trunk/ )
+> does not produce the same tar.xz file as found within
+drakx-installer-stage2 sources.
+> For example, the tar.gz produced by "make dist" does not contain the
+"kernel", "perl-install/install" directories, etc.
+> Also, inside the tar, the first directory is: "drakxtools-15.29", rather
+than "drakx-installer-stage2-15.29".  It is also
+> only 2.4MB instead of about 4.3MB.
+>
+> Any suggestions?
+
+Yes, you need to go into install subdirectory (if I remember the name
+correctly)
+-------------- next part --------------
+An HTML attachment was scrubbed...
+URL: </pipermail/mageia-dev/attachments/20130322/9d51da93/attachment.html>
+