[Mageia-dev] drakxtools & drakx-installer-stage2 (mga#9428)

Fri Mar 22 23:20:48 CET 2013

On 23 March 2013 05:12, AL13N <alien at rmail.be> wrote:
+
+> Op vrijdag 22 maart 2013 07:38:56 schreef Frank Griffin:
+> > On 03/22/2013 07:20 AM, Glen Ogilvie wrote:
+> [...]
+> > > 1. How does the src tar.xz file for drakx-installer-stage2 get
+> > > created?   I assume it comes from a
+> > > build of svn://svn.mageia.org/svn/soft/drakx/trunk
+> > > <http://svn.mageia.org/svn/soft/drakx/trunk>, but can't find how it
+> > > ends up as a tar.xz
+> >
+> > I'm maybe about two days ahead of you on this, but here's what I think
+> > happens, FWIW.  You do your checkout, and then in the mdk-stage1
+> > subdirectory, do a "make dist-svn".  This should produce the tar.xz in
+> > the mdk-stage1 directory.
+> [...]
+>
+> "make dist" actually...
+>
+> it will target make "dist-svn" or "make dist-git" depending on if you're
+> using
+> git-svn or not.
+>
+> be advised that dist-svn uses the BASE and any uncommitted change will not
+> be
+> applied.
+>
+> dist-git however, you can commit without pushing them and that will be
+> used.
+>
+>
+I've had a good play around with make dist.
+It seems to me, like running make dist in the perl-install directory,
+(svn://svn.mageia.org/svn/soft/drakx/trunk/ )
+does not produce the same tar.xz file as found within
+drakx-installer-stage2 sources.
+For example, the tar.gz produced by "make dist" does not contain the
+"kernel", "perl-install/install" directories, etc.
+Also, inside the tar, the first directory is: "drakxtools-15.29", rather
+than "drakx-installer-stage2-15.29".  It is also
+only 2.4MB instead of about 4.3MB.
+
+Any suggestions?
+
+Regards
+Glen
+-------------- next part --------------
+An HTML attachment was scrubbed...
+URL: </pipermail/mageia-dev/attachments/20130323/24a54bf4/attachment.html>
+