diff options
Diffstat (limited to 'mdk-stage1/rp-pppoe/README')
| -rw-r--r-- | mdk-stage1/rp-pppoe/README | 87 |
1 files changed, 0 insertions, 87 deletions
diff --git a/mdk-stage1/rp-pppoe/README b/mdk-stage1/rp-pppoe/README deleted file mode 100644 index 269fc16be..000000000 --- a/mdk-stage1/rp-pppoe/README +++ /dev/null @@ -1,87 +0,0 @@ -pppoe: a PPP-over-Ethernet redirector for pppd -Copyright (C) 2001 Roaring Penguin Software Inc. - -Much inspiration from an earlier client by Luke Stras. - -The MSS clamping was inspired by mssclampfw by Marc Boucher <marc@mbsi.ca> -with acknowledgements to Rebel.com (http://www.rebel.com). However, the -actual MSS clamping code is original and is licensed under the GPL, unlike -the original mssclampfw. - -Introduction -============ - -pppoe is a user-space redirector which permits the use of PPPoE -(Point-to-Point Over Ethernet) with Linux. PPPoE is used by many -ADSL service providers. - -Installation -============ - -Requirements ------------- - -1) Linux 2.2.9 or later on Intel, Sparc or PowerPC. It may work on - Alpha, too -- anyone care to let me know? - - OR - - Linux 2.0.36 or later. - - OR - - FreeBSD, NetBSD or OpenBSD with BPF support. I have access only - to FreeBSD. In general, I can't answer questions about the *BSD's - as well as I can about Linux. - - -2) pppd 2.3.10 or later. Versions 2.3.7 and later work unless you use - demand-dialling. For demand dialling, you *must* use 2.3.10 or later. - -QUICKSTART ----------- - -If you're lucky, the "quickstart" method will work. After unpacking -the archive, become root and type: - - ./go - -This should configure, compile and install the software and set up your -ADSL connection. You'll have to answer a few questions along the way. - -If you want the GUI wrapper, type: - - ./go-gui - -If ./go and ./go-gui didn't work, read the rest of this README. - -Compiling ---------- - -Compile and install pppd if you don't already have it. Then: - -1) Unpack: - - $ tar xzvf rp-pppoe-xxx.tar.gz - -2) Change to source directory: - - $ cd src - -3) Configure: - - $ ./configure - -4) Compile: - - $ make - -4) Install (this step must be done as root) - - # make install - -5) Now read doc/HOW-TO-CONNECT - --- -David F. Skoll <dfs@roaringpenguin.com> | Roaring Penguin Software Inc. -http://www.roaringpenguin.com | Linux and UNIX Specialists
\ No newline at end of file |