Sed command get version number from spec file and increment last
number by one. Work like old awk command was intended to work.

Source: https://stackoverflow.com/questions/14348432/how-to-find-replace-and-increment-a-matched-number-with-sed-awk/14348899

(cherry picked from commit bfda3cc2acdea827909e6c89bda5bbb5140cda6c)

Add strong relation between initscripts and initscripts-service.
Also update Obsoletes of initscripts package.

Obsoletes with initscripts < 10.10 in order to allow the initscripts-service package to be installed while upgrading from initscripts < 10.10

Translated using Weblate (Friulian)

Co-authored-by: Fabio Tomat <f.t.public@gmail.com>

* Translated using Weblate (Portuguese (Brazil))
* Translated using Weblate (Swedish)

Co-authored-by: Gustavo Costa <xfgusta@gmail.com>
Co-authored-by: Anders Jonsson <anders.jonsson@norsjovallen.se>

In 76226a34 ("ifup-eth: apply PERSISTENT_DHCLIENT to IPv6 dhclient daemon"),
one PERSISTENT_DHCLIENT option works for both IPv4 and IPv6, so the IPv4
and IPv6 settings are consistent. However, the user settings for IPv4 and IPv6
are limited.

For example, users try to adopt both IPv4 and IPv6 protocol. DHCPv6 servers
may be not stable as DHCP servers, thus the expectation for obtaining IPv6
address is lower than IPv4 address. For users, IPv4 address must be
obtained for the basic communication. So the PERSISTENT_DHCLIENT option is
set to be "yes | 1" for IPv4 address. However, the network service may be
stuck until it fails due to missing DHCPv6 servers, and the remaining devices also
cannot obtain both IPv4 and IPv6 addresses. The problem is very serious for users.

Here, I add a new PERSISTENT_DHCLIENT_IPV6 option only for IPv6 dhclient daemon,
so users can set IPv4 and IPv6 separately.

Fixes: 76226a3 ("ifup-eth: apply PERSISTENT_DHCLIENT to IPv6 dhclient daemon")
Signed-off-by: Zhiqiang Liu <liuzhiqiang26@huawei.com>