From 0a121a8ecd6de894c14d60daf9da2022ec47405c Mon Sep 17 00:00:00 2001 From: Guillaume Cottenceau Date: Mon, 11 Jun 2001 13:49:39 +0000 Subject: Initial revision --- mdk-stage1/rp-pppoe/README | 87 ++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 87 insertions(+) create mode 100644 mdk-stage1/rp-pppoe/README (limited to 'mdk-stage1/rp-pppoe/README') diff --git a/mdk-stage1/rp-pppoe/README b/mdk-stage1/rp-pppoe/README new file mode 100644 index 000000000..269fc16be --- /dev/null +++ b/mdk-stage1/rp-pppoe/README @@ -0,0 +1,87 @@ +pppoe: a PPP-over-Ethernet redirector for pppd +Copyright (C) 2001 Roaring Penguin Software Inc. + +Much inspiration from an earlier client by Luke Stras. + +The MSS clamping was inspired by mssclampfw by Marc Boucher +with acknowledgements to Rebel.com (http://www.rebel.com). However, the +actual MSS clamping code is original and is licensed under the GPL, unlike +the original mssclampfw. + +Introduction +============ + +pppoe is a user-space redirector which permits the use of PPPoE +(Point-to-Point Over Ethernet) with Linux. PPPoE is used by many +ADSL service providers. + +Installation +============ + +Requirements +------------ + +1) Linux 2.2.9 or later on Intel, Sparc or PowerPC. It may work on + Alpha, too -- anyone care to let me know? + + OR + + Linux 2.0.36 or later. + + OR + + FreeBSD, NetBSD or OpenBSD with BPF support. I have access only + to FreeBSD. In general, I can't answer questions about the *BSD's + as well as I can about Linux. + + +2) pppd 2.3.10 or later. Versions 2.3.7 and later work unless you use + demand-dialling. For demand dialling, you *must* use 2.3.10 or later. + +QUICKSTART +---------- + +If you're lucky, the "quickstart" method will work. After unpacking +the archive, become root and type: + + ./go + +This should configure, compile and install the software and set up your +ADSL connection. You'll have to answer a few questions along the way. + +If you want the GUI wrapper, type: + + ./go-gui + +If ./go and ./go-gui didn't work, read the rest of this README. + +Compiling +--------- + +Compile and install pppd if you don't already have it. Then: + +1) Unpack: + + $ tar xzvf rp-pppoe-xxx.tar.gz + +2) Change to source directory: + + $ cd src + +3) Configure: + + $ ./configure + +4) Compile: + + $ make + +4) Install (this step must be done as root) + + # make install + +5) Now read doc/HOW-TO-CONNECT + +-- +David F. Skoll | Roaring Penguin Software Inc. +http://www.roaringpenguin.com | Linux and UNIX Specialists \ No newline at end of file -- cgit v1.2.1