diff options
Diffstat (limited to 'perl-install/share')
| -rw-r--r-- | perl-install/share/po/DrakX.pot | 30 |
1 files changed, 15 insertions, 15 deletions
diff --git a/perl-install/share/po/DrakX.pot b/perl-install/share/po/DrakX.pot index a536b4354..7af5a072c 100644 --- a/perl-install/share/po/DrakX.pot +++ b/perl-install/share/po/DrakX.pot @@ -7666,17 +7666,17 @@ msgstr "" #: network/adsl.pm:19 #, c-format -msgid "use pppoe" +msgid "use PPPoE" msgstr "" #: network/adsl.pm:20 #, c-format -msgid "use pptp" +msgid "use PPTP" msgstr "" #: network/adsl.pm:21 #, c-format -msgid "use dhcp" +msgid "use DHCP" msgstr "" #: network/adsl.pm:22 @@ -7708,8 +7708,8 @@ msgstr "" #, c-format msgid "" "The most common way to connect with adsl is pppoe.\n" -"Some connections use pptp, a few use dhcp.\n" -"If you don't know, choose 'use pppoe'" +"Some connections use PPTP, a few use DHCP.\n" +"If you don't know, choose 'use PPPoE'" msgstr "" #: network/adsl.pm:41 network/netconnect.pm:761 @@ -13221,7 +13221,7 @@ msgid "" "\n" " This wizard routine will:\n" " \t1) Ask you to select either 'thin' or 'fat' clients.\n" -"\t2) Setup dhcp.\n" +"\t2) Setup DHCP.\n" "\t\n" "After doing these steps, the wizard will:\n" "\t\n" @@ -13327,11 +13327,11 @@ msgid "" " of client-specific configuration files that ClusterNFS provides.\n" "\t\t\t\n" " Note: The '#type' entry is only used by drakTermServ. Clients can either be 'thin'\n" -" or 'fat'. Thin clients run most software on the server via xdmcp, while fat clients run \n" +" or 'fat'. Thin clients run most software on the server via XDMCP, while fat clients run \n" " most software on the client machine. A special inittab, %s is\n" " written for thin clients. System config files xdm-config, kdmrc, and gdm.conf are \n" -" modified if thin clients are used, to enable xdmcp. Since there are security issues in \n" -" using xdmcp, hosts.deny and hosts.allow are modified to limit access to the local\n" +" modified if thin clients are used, to enable XDMCP. Since there are security issues in \n" +" using XDMCP, hosts.deny and hosts.allow are modified to limit access to the local\n" " subnet.\n" "\t\t\t\n" " Note: The '#hdw_config' entry is also only used by drakTermServ. Clients can either \n" @@ -13400,7 +13400,7 @@ msgid "" " \tby mkinitrd-net, and the entries in /etc/dhcpd.conf, to serve up the boot image to \n" " \teach diskless client.\n" "\n" -" \tA typical tftp configuration file looks like:\n" +" \tA typical TFTP configuration file looks like:\n" " \t\t\n" " \tservice tftp\n" "\t\t\t{\n" @@ -13899,7 +13899,7 @@ msgstr "" #: standalone/drakbackup:153 #, c-format -msgid "Expect is an extension to the Tcl scripting language that allows interactive sessions without user intervention." +msgid "Expect is an extension to the TCL scripting language that allows interactive sessions without user intervention." msgstr "" #: standalone/drakbackup:154 @@ -15971,7 +15971,7 @@ msgstr "" #: standalone/drakconnect:695 #, c-format -msgid "No Ip" +msgid "No IP" msgstr "" #: standalone/drakconnect:696 @@ -18666,7 +18666,7 @@ msgstr "" #, c-format msgid "" "specifies the identifier sent to the remote host and the\n" -"type to use in the phase 1 negotiation. address, fqdn,\n" +"type to use in the phase 1 negotiation. address, FQDN,\n" "user_fqdn, keyid and asn1dn can be used as an idtype.\n" "they are used like:\n" "\tmy_identifier address [address];\n" @@ -18675,7 +18675,7 @@ msgid "" "\tmy_identifier user_fqdn string;\n" "\t\tthe type is a USER_FQDN (user fully-qualified\n" "\t\tdomain name).\n" -"\tmy_identifier fqdn string;\n" +"\tmy_identifier FQDN string;\n" "\t\tthe type is a FQDN (fully-qualified domain name).\n" "\tmy_identifier keyid file;\n" "\t\tthe type is a KEY_ID.\n" @@ -18706,7 +18706,7 @@ msgid "" "phase 1 negotiation. This directive must be defined. \n" "algorithm is one of following: \n" "\n" -"des, 3des, blowfish, cast128 for oakley.\n" +"DES, 3DES, blowfish, cast128 for oakley.\n" "\n" "For other transforms, this statement should not be used." msgstr "" |