drakbug_report This toolYou can start this tool from the command line, by typing drakbug_report as root. can only be started and used on the command line. It is advised to write the output of this command to a file, for instance by doing drakbug_report > drakbugreport.txt, but make sure you have enough disk space first: the file can easily be several GBs large. The output is far too large to attach to a bug report without first removing the unneeded parts. Tyto následující příkazy shromažďují informace o vašem systému: lspci pci_devices dmidecode fdisk scsi /sys/bus/scsi/devices lsmod cmdline pcmcia: stab usb partitions cpuinfo syslog Xorg.log monitor_full_edid stage1.log ddebug.log install.log fstab modprobe.conf lilo.conf grub: menu.lst grub: install.sh grub: device.map xorg.conf urpmi.cfg modprobe.preload sysconfig/i18n /proc/iomem /proc/ioport mageia version rpm -qa df At the time this help page was written, the "syslog" part of this command's output was empty, because this tool had not yet been adjusted to our switch to systemd. If it is still empty, you can retrieve the "syslog" by doing (as root) journalctl -a > journalctl.txt. If you don't have a lot of diskspace, you can, for instance, take the last 5000 lines of the log instead with: journalctl -a | tail -n5000 > journalctl5000.txt.