In this screen you can see the content of your hard drive(s) and see the solutions the DrakX partitioning wizard found for where to install Mageia. The options available from the list below will vary depending on your particular hard drive(s) layout and content. Utilizza le partizioni esistenti Se questa opzione è disponibile allora saranno trovate partizioni esistenti Linux compatibili e potrebbero essere usate per l'installazione. Utilizza lo spazio libero Se hai dello spazio libero sul tuo hard drive questa opzione lo utilizzerà per la tua nuova installazione di Mageia. Usa lo spazio libero di una partizione Windows Se hai dello spazio libero su di una partizione Windows esistente l'installer potrebbe offrirti di utilizzarla. This can be a useful way of making room for your new Mageia installation, but is a risky operation so you should make sure you have backed up all important files! Note that this involves shrinking the size of the Windows partition. The partition must be "clean", meaning that Windows must have closed down correctly the last time it was used. It must also have been defragmented, although this is not a guarantee that all files in the partition have been moved out of the area that is about to be used. It is highly recommended to back up your personal files. With this option, the installer displays the remaining Windows partition in light blue and the future Mageia partition in dark blue with their intended sizes just under. You have the possibility to adapt these sizes by clicking and draging the gap between both partitions. See the screen-shot below. Formatta e utilizza tutto il disco Questa opzione userà l'intero disco per Mageia. Nota bene! Questo cancellerà TUTTI i dati sull'hard drive selezionato. Fai attenzione! If you intend to use part of the disk for something else, or you already have data on the drive that you are not prepared to lose, then do not use this option. Personalizzato This gives you complete control over the placing of the installation on your hard drive(s). Some newer drives are now using 4096 byte logical sectors, instead of the previous standard of 512 byte logical sectors. Due to lack of available hardware, the partitioning tool used in the installer has not been tested with such a drive. Also some ssd drives now use an erase block size over 1 MB. We suggest to pre-partition the drive, using an alternative partitioning tool like gparted, if you own such a device, and to use the following settings: "Align to" "MiB" "Free space preceding (MiB)" "2" Assicurati anche che tutte le partizioni siano create con un numero pari di megabytes.