Föreslagen partitionering
In this screen you can see the content of your hard drive(s) along with the
DrakX partitioning proposals for where to install Mageia.
The actual options available from those shown below will vary according to
the layout and content of your particular hard drive(s).
Huvudsakliga alternativ
Använd befintliga partitioner
Om det här alternativet är tillgängligt så har kompatibla Linux-partitioner
hittats och kan användas för installation.
Använd oanvänt utrymme
Om du har ledigt utrymme på din hårddisk kommer det här alternativet att
använda det för att installera Mageia.
Använd oanvänt utrymme i en
Windows-partition
If you have unused space on an existing Windows partition, the installer may
offer to use it. This can be a useful way of making room for your new Mageia
installation but see the warning below.
With this option, the installer displays the remaining Windows partition in
light blue and the proposed Mageia partition in dark blue with their
intended sizes just underneath. You have the option to modify these sizes by
clicking and dragging the gap between both partitions. See the following
screenshot:
This involves shrinking the size of the Windows partition, and therefore is
a risky operation, so you should make sure you have backed up all important
files before proceeding.
The partition must be "clean", meaning that Windows must have closed down
correctly the last time it was used. It must also have been defragmented,
although this is not a guarantee that all files in the partition have been
moved out of the area that is about to be used for Mageia.
Radera och använd hela hårddisken
Det här alternativet kommer att allokera hela disken för Mageia
This will erase ALL data on the selected hard drive. Take care! If you
intend to use part of the disk for something else, or you already have data
on the drive that you are not prepared to lose, then do not use this option.
Anpassad diskpartitionering
Detta ger dig fullständig kontroll över placeringen av installationen på
din/a disk/ar.
If you are not using the Custom disk partitioning
option, then the installer will allocate the available space according to
the following rules:
If the total available space is less than 50 GB, then only one partition is
created. This will be the / (root) partition.
Om det totala tillgängliga utrymmet är större än 50 GB så skapas tre
partitioner
6/19 of the total available place is allocated to /
with a maximum of 50 GB
1/19 är allokerat till swapmed maximalt 4 GB
the rest (at least 12/19) is allocated to /home
This means that from 160 GB or greater available space, the installer will
create three partitions:
50 GB för /
4 GB för swap
och det som återstår till /home
If you are using a UEFI system, the ESP (EFI System Partition) will be
automatically detected - or created if it does not exist yet - and mounted
on /boot/EFI. The Custom disk
partitioning option is the only one that allows to check it has
been correctly done.
If you are using a Legacy (also known as BIOS) system with a GPT partitioned
disk, you need to create a BIOS boot partition if it doesn't already
exist. It should be about 1 MiB with no mount point. It can be created with
the Installer, under Custom disk partitioning, like any
other partition. Be sure to select BIOS boot partition
for
filesystem type.
Se för information om hur du fortsätter.
Some newer drives are now using 4096 byte logical sectors, instead of the
previous standard of 512. Due to lack of available hardware, the
partitioning tool used in the installer has not been tested with such a
drive.
Some SSD devices now use an erase block size over 1 MB. If you have such a
device we suggest that you partition the drive in advance, using an
alternative partitioning tool like gparted, and to use the following
settings:
Justera till = MiB
Free space preceding (MiB) = 2
Also make sure all partitions are created using an even number of megabytes.