aboutsummaryrefslogtreecommitdiffstats
path: root/sysconfig/network-scripts
Commit message (Collapse)AuthorAgeFilesLines
* ifup: set valid_lft and preferred_lft to forever for static ipBlake Caldwell2016-05-301-0/+3
|
* ifdown-eth: fix comparisonLukas Nykryn2015-12-251-1/+1
|
* network-scripts: DEVICE and HWADRR could be quoted by apostropheLukas Nykryn2015-10-273-4/+4
|
* ifup-wireless: fix calling of phy_wireless_deviceLukas Nykryn2015-10-161-1/+4
|
* ifdown: clean ipv4 localhost addressesLukas Nykryn2015-10-151-7/+7
|
* ifup-eth: some bridge options are applied laterLukas Nykryn2015-09-161-1/+3
|
* network-functions: fix wireless detectionLukas Nykryn2015-08-061-1/+1
|
* ifup-post: should be interpreted in bashLukas Nykryn2015-05-251-1/+1
|
* bonding: warn if the ifup for slave device failedLukas Nykryn2015-05-071-1/+1
|
* ifup: don't call NM for loopbackLukas Nykryn2015-05-061-1/+1
|
* ifup: add missing quotesLukas Nykryn2015-04-241-1/+1
|
* network-functions: fix change_resolv_conf after grep updateLukas Nykryn2015-04-091-4/+4
|
* ifup-aliases: don't return with error when arping failsLukas Nykryn2015-04-051-1/+2
|
* ifup-aliases: inherit ARPCHECK from parent deviceLukas Nykryn2015-02-271-1/+2
|
* ifdown-eth: use scope host for loLeon Kos2015-02-041-2/+7
|
* ifup-ipv6: set accept_ra to 2 when IPV6FORWARDING=yes and IPV6_AUTOCONF=yesLukas Nykryn2015-01-191-1/+5
|
* ifup-post: check resolve.conf also with DNS2Lukas Nykryn2015-01-161-1/+8
|
* ifup-aliases: do not fail when only ipv6 addr is specifiedLukas Nykryn2015-01-151-0/+5
|
* network-functions: is_available_wait should wait even in the case that ↵Lukas Nykryn2015-01-121-4/+2
| | | | is_available returns 2
* ifdown-post: remove resolv.conf only in specific casesLukas Nykryn2015-01-081-1/+2
|
* network-functions: fix check in install_bonding_driverLukas Nykryn2015-01-021-1/+1
|
* ifdown-ipv6: reset addrgenmode to eui64 for deviceLukas Nykryn2014-12-161-0/+1
|
* ifup: fix typoLukas Nykryn2014-12-161-1/+1
|
* network-functions: reeplace iwconfig with iwValdis Kletnieks2014-12-101-2/+2
|
* improve_check_for_bond_master_in_install_bonding_driverAshish Samant2014-12-081-2/+14
| | | | | | | | | | | | | | | | | | The current grep check (fgrep -sqx) in install_bonding_driver, to determine whether bond master exists, fails when there are multiple bond masters. The fix assumes that multiple bond masters are on different lines in the file "/sys/class/net/bonding_masters", while they are in fact on the same line. Since fgrep -sqx checks for the entire line,it will never match any one bond master within the line and always fail if there are multiple bonds. This patch improves the check by creating a new function, bond_master_exists() to handle this and other conditions. Orabug: 19897586 Signed-off-by: Ashish Samant <ashish.samant@oracle.com> Signed-off-by: John Haxby <john.haxby@oracle.com> Acked-by: Mukesh Kacker <mukesh.kacker@oracle.com>
* adjust LINKDELAY when STP is onLaine Stump2014-11-121-1/+10
| | | | | | | | | | | | | | | | | | | | | | | | | | This resolves: https://bugzilla.redhat.com/show_bug.cgi?id=1162822 When ifup is called on an interface that has BOOTPROTO=dhcp, ifup-eth will call network-functions:check_link_down() to wait for carrier on the interface before starting dhclient. If the interface happens to be a bridge device, carrier will not come on until at least one attached device is in "forwarding" mode. If the bridge has STP enabled, it takes at least $DELAY * 2 + 5 seconds (sometimes slightly longer) for any attached device to go into forwarding mode. However, check_link_down() will only wait for max(${LINKDELAY}, 5) seconds for carrier, and there are *many* existing configs that have STP enabled but no setting for LINKDELAY. Every one of those configs will now fail to ifup the bridge device. The solution implemented in this patch is for ifup-eth to set LINKDELAY to at least ${DELAY} * 2 + 7 when the device is a bridge an STP is enabled. Since check_link_down() returns within .5 sec of carrier coming up, the worst effect this could have would be to take longer to fail in the case of a config where carrier was *never* going to come up. Otherwise, it will not create any more delay than is already present in cases that currently work, and will cause many other configs to become unbroken.
* ifup,vlan: fix typoLukas Nykryn2014-10-241-1/+1
|
* network_function: return immediately when device is presentLukas Nykryn2014-10-071-1/+4
| | | | | Conflicts: sysconfig/network-scripts/network-functions
* add configurable DEVTIMEOUTLukas Nykryn2014-10-073-2/+19
|
* network-functions: grep->fgrep in bonding masters matchingLukas Nykryn2014-09-191-1/+1
|
* network-functions: improve bonding_masters grepLukas Nykryn2014-09-161-1/+1
| | | | kudos to john.haxby@oracle.com
* ifup: if we were unable to determine DEVICE always call nmcli upLukas Nykryn2014-09-161-1/+1
|
* ifup-tunnel: call ifup-ipv6 in the endLukas Nykryn2014-09-161-0/+3
|
* ifup: also set multicast_snooping after the bridge is upLukas Nykryn2014-09-161-1/+1
|
* network-functions: ETHTOOL_DELAY introduction patchLukas Nykryn2014-09-091-0/+1
|
* custom naming for VLAN devicesLukas Nykryn2014-09-091-15/+22
|
* ifup-wireless: add support for wowlanEduardo Minguez2014-09-091-0/+5
| | | | | Conflicts: sysconfig/network-scripts/ifup-wireless
* ifup-wireless: add support for wowlan (second part)Eduardo Minguez2014-09-091-0/+5
|
* ifup-aliases: do not bring up ipv6 for range filesLukas Nykryn2014-08-081-0/+1
|
* ifup-aliases: improve duplicate address detectionLukas Nykryn2014-07-241-6/+8
|
* network-functions: handle BONDING_OPTS betterJirka Klimes2014-07-241-3/+29
|
* ifup-eth: some options for bridge can be applied after the bridge is upLukas Nykryn2014-04-291-0/+10
| | | | | Conflicts: sysconfig/network-scripts/ifup-eth
* move ppp support to ppp packageLukas Nykryn2014-04-242-208/+0
|
* is_nm_handling: fix RELukas Nykryn2014-04-011-1/+1
|
* bonding: match whole name of interfaceLuke Bigum2014-03-311-1/+1
|
* network: add support for team devicesJiri Pirko2014-03-312-0/+20
| | | | | | | | | | | | | | | | | | Currently, team masters and slaves are supported via ifup-Team* and ifdown-Team* scripts shipped in teamd package. It uses somehow ugly workaround where user have to specify DEVIVETYPE to "Team" or "TeamPort". This turned out to be non-optimal solution as this is confusing users. Also it does not work when TYPE is set. So fix this by adding the team support hooks directly into initscripts. Now for team port, user needs only to set: TEAM_MASTER="teamx" and for team master, user needs only to set: TEAM_CONFIG="...whatever..." Signed-off-by: Jiri Pirko <jiri@resnulli.us>
* ifup-wireless: fix syntax errorkc8hfi@gmail.com2014-03-311-1/+1
|
* bridging: add possibility to set prio and ageingLukas Nykryn2014-03-191-0/+2
|
* ifup: add possibility to specify value for -w parameter of arpingLukas Nykryn2014-03-192-2/+2
|
* network: try to not compete with NM during bootLukas Nykryn2014-03-112-0/+6
|
generated by cgit v1.2.1 (git 2.21.0) at 2024-11-21 21:18:44 +0000