diff options
| -rw-r--r-- | sysconfig/network-scripts/ifup-escon | 53 | ||||
| -rw-r--r-- | sysconfig/network-scripts/network-functions | 8 |
2 files changed, 1 insertions, 60 deletions
diff --git a/sysconfig/network-scripts/ifup-escon b/sysconfig/network-scripts/ifup-escon deleted file mode 100644 index d2b0470c..00000000 --- a/sysconfig/network-scripts/ifup-escon +++ /dev/null @@ -1,53 +0,0 @@ -#!/bin/bash -# -# /etc/sysconfig/network-scripts/ifup-escon -# -# the escon network interface is a point-to-point interface on S/390 machines -# which uses the ctc module. -# -# To get the ctc module to load automatically at boot, you will need to -# add the following line to /etc/modprobe.conf: -# -# alias escon0 ctc -# - -cd /etc/sysconfig/network-scripts -. network-functions - -CONFIG=$1 -[ -f "$CONFIG" ] || CONFIG=ifcfg-$CONFIG -source_config - -if [ "$2" = "boot" -a "${ONBOOT}" = "no" ] -then - exit -fi -[ -n "${MTU}" ] && opts="${opts} mtu ${MTU}" - -ifconfig ${DEVICE} ${IPADDR} ${opts} pointopoint ${REMIP} netmask ${NETMASK} - -# Wait for the device to come up - the chandev'ified ctc driver can take -# quite a while... -timeout=0 -while ! ping -w 30 -c 1 ${REMIP} &>/dev/null; do - timeout=$(($timeout + 1)) - if [ $timeout = 20 ]; then - echo $"ERROR: ${DEVICE} did not come up!" - break - fi -done - -if [ "${NETWORK}" != "" ] ; then - route add -host ${REMIP} metric 1 ${DEVICE} -fi - -. /etc/sysconfig/network - -if [ "${GATEWAY}" != "" ]; then - if [ "${GATEWAYDEV}" = "" -o "${GATEWAYDEV}" = "${DEVICE}" ]; then - # set up default gateway - route add default gw ${GATEWAY} - fi -fi - -/etc/sysconfig/network-scripts/ifup-post $1 diff --git a/sysconfig/network-scripts/network-functions b/sysconfig/network-scripts/network-functions index 5724e9ba..8d14a780 100644 --- a/sysconfig/network-scripts/network-functions +++ b/sysconfig/network-scripts/network-functions @@ -77,12 +77,6 @@ source_config () IUCV) DEVICETYPE="iucv" ;; - ESCON) - DEVICETYPE="escon" - ;; - QETH) - DEVICETYPE="eth" - ;; esac [ -z "$DEVICETYPE" ] && DEVICETYPE=`echo ${DEVICE} | sed "s/[0-9]*$//"` @@ -341,7 +335,7 @@ configure_ccwgroup_device () if [ "$TYPE" = "QETH" ]; then DIR="/sys/bus/ccwgroup/drivers/qeth" elif - [ "$TYPE" = "CTC" -o "$TYPE" = "ESCON" ]; then + [ "$TYPE" = "CTC" ]; then DIR="/sys/bus/ccwgroup/drivers/ctc" elif [ "$TYPE" = "LCS" ]; then |